Fitting Instructions

Please read through instructions completely and prepare everything prior to starting. The purpose of the boil and bite system is to mould your teeth into the top and bottom plates of the mouthpiece.

Care needs to be taken to ensure that the water isn’t too hot, and that the exposure to the hot water isn’t excessively long, to avoid the mould deforming.

Step 1

Place a cup or bowl of water in
the microwave and heat until
nearly boiling.

Step 2

By pressing in the side adjustment tabs, adjust the NitePro so that the lower jaw is advanced slightly forward on the top jaw. When you are moulding to your teeth, the lower jaw should be slightly advanced (forward) as that is the effect to be achieved.

Step 3

Place the mouthpiece into the water for around 30-40 seconds. Remove with a pair of tongs to avoid burns. Warning, do not place in water for too long as the teeth mould will shrink up.

Step 4

When removed from the boiling water, place in a cup orbowl of room temperature water for 2-3 seconds.

Step 5

Place in mouth. Position upper and lower teeth with the lower jaw slightly forward and bite down hard to mould the mouthpiece to the shape of your teeth. If the mould is not soft enough, repeat with hotter water until the correct.

Step 6

Once moulded, place in cold water to lock the shape. Adjust the jaw advancement position for maximum effect. The process can be repeated if required.